Weheat

The Weheat integration集成将 Home Assistant 与您的设备、服务等连接和集成。 [Learn more] allows you to display your Weheat devices through Home Assistant.

Supported devices

The Blackbird, Sparrow and Flint heat pumps are supported.

Prerequisites

• You need a Weheat account, username, and password
• When adding the integration in Home Assistant, you will be prompted to enter a Name, Client ID, and Client Secret.
  • The name is arbitrary, the ID and secret are provided in the knowledge base.
• During setup of the integration in Home Assistant, you will be redirected to the Weheat login provider. Log in using your username and password.
  • After login, select link account to link your account.

配置

要将 Weheat integration 添加到您的 Home Assistant 实例中，请使用此 My 按钮：

Entities

Sensors

The Weheat integration provides the following sensors:

• Output power: Thermal power added to the water in Watts
• Input power: Electrical power in Watts
• COP: The Coefficient of performance between the above two power measurements
• Water inlet temperature: The heat pump water inlet temperature in °C
• Water outlet temperature: The heat pump water outlet temperature in °C
• Water target temperature: Target for the water temperature in °C
• Central heating inlet temperature: The central heating inlet temperature in °C
• Outside temperature: Outside temperature in °C
• Current room temperature: Current room temperature in °C
• Room temperature setpoint: Setpoint for the room temperature in °C
• Electricity used: Total electricity used in kWh
• Energy output: Total output generated in kWh
• State: The current heat pump state
• DHW top temperature: The domestic hot water temperature in the top of the vessel in °C (optional)
• DHW bottom temperature”: The domestic hot water temperature in the bottom of the vessel in °C (optional)
• Compressor RPM: The rpm of the compressor fan.
• Compressor percentage: The percentage of the compressor fan. Can exceed 100% for some models.

Depending on the model/installation, states for the Indoor Unit states are available:

• Indoor unit water pump
• Indoor unit auxiliary water pump
• Indoor unit DHW valve or water pump
• Indoor unit gas boiler heating allowed - Note: This may be True even when no gas boiler is installed or active at this time.
• Indoor unit electric heater

Data updates

The integration is polling数据轮询是定期查询设备或服务以检查更新或检索数据的过程。通过定义自定义轮询间隔，您可以控制系统检查新数据的频率，这有助于优化性能并减少不必要的网络流量。 [Learn more] and retrieves data every 30 seconds from the cloud.

Actions

This integration does not provide any actions.

Known limitations

There is currently no way to control the heat pump via this integration.

Troubleshooting

In case no devices are discovered, make sure that you can log in to the Weheat portal and the correct heat pumps are visible there. If they are available there, contact Weheat support.

Remove integration

This integration follows standard integration removal, no extra steps are required.

从Home Assistant中移除集成实例

1. 前往 设置 > 设备与服务 并选择集成卡片。
2. 从设备列表中，选择要删除的集成实例。
3. 在条目旁边，选择三个点 菜单。然后，选择 删除。