WaterFurnace

The WaterFurnace integration集成将 Home Assistant 与您的设备、服务等连接和集成。 [Learn more] communicates with the WaterFurnace Symphony website’s WebSocket to show you many of the sensors in your system. While not an official API, this is the same backend the Symphony website is based on, and should be reasonably stable.

The sensors provided include:

• Thermostat Setpoint
• Thermostat Current Temp
• Leaving Air Temp
• Entering Water Loop Temp
• Current Humidity
• Current Humidity Setpoint
• Total system power (in Watts)
• Furnace Mode
• Compressor Power
• Fan Power
• Aux Power
• Loop Pump Power
• Compressor Speed
• Fan Speed

Configuration

To use Waterfurnace in your installation, add the following to your configuration.yamlconfiguration.yaml 文件是 Home Assistant 的主要配置文件。它列出了要加载的集成及其特定配置。在某些情况下，需要直接在 configuration.yaml 文件中手动编辑配置。大多数集成可以在 UI 中配置。 [Learn more] file. 在更改了configuration.yamlconfiguration.yaml 文件是 Home Assistant 的主要配置文件。它列出了要加载的集成及其特定配置。在某些情况下，需要直接在 configuration.yaml 文件中手动编辑配置。大多数集成可以在 UI 中配置。 [Learn more] 文件后，重启 Home Assistant 以应用更改。 该集成现在显示在集成页面的 设置 > 设备与服务 下。其实体在集成卡片上以及实体标签上列出。

# Example configuration.yaml entry
waterfurnace:
  username: YOUR_USERNAME
  password: YOUR_PASSWORD

Limitations

The WebSocket interface used by this module requires active polling to prevent the server side shuts down the connection. By default, this polling is happening every 10 seconds. All sensors are updated during every polling cycle.

While this is communicating with a thermostat, geothermal systems operate most efficiently when setbacks are not used, and the home is kept at a constant temperature. It remains useful to collect the data from the system to understand its performance, but a full climate interface won’t be implemented.